Projet G5

I have built the Version 3. By now there are just some simple Modifications planned like a Master Volume and a line out.And hopefully a Reverb or a Tremolo. The Plan looks nice, does it work with G5V3 also? I have some other question too, I would like to built an 8 Ohms and a 4 Ohm Output, can I wir...

Hi I'm going to rebuild my G5, because it was the first amp I really made and it just looks like it. Now I think I am more experienced, because I built a lot of effects a basspreamp and so on. But I would like to build in some modifications. Some are very well described in the manual but then I had ...

Okay, I think I will try to replace them and make mesaures if it fits. I can use the bias document in the dowload area. Okay two more questions and I'm done. I'm planning to install an triode/Pentode switch. But I'm not sure what switch I should use and how to make the wiring. From the Pin 4 of V2 w...

Thank you for your answers, I was on vacation and now I'm back. My G5 is built and it is working. (After some Troubleshooting with the TT Forum) But I have a question about the tubes. A lot of the builders of the previous version said that every tube can be put into the G5 and you don't have to worr...

Thanks a lot.

Is it necessary to make a little hole or can I just drive the screws for the tube sockets in the chassis?

In the layout you made the ground on the screws of the transformers. Is this alright?

I said I'll be back and guess what? I am back! The G5 is my first amp and I built only a few stompboxes before. Now I have a problem with the screws. The kit was deliviered with a screw kit but I'm not really sure what screw to use for what. There are many smaller, fatter ones (ca. 4 cm diameter) an...

Thank you, that was exactly what I'm looking for. And very quick answer, if have more questions I will be back. 8)

Hi

Is the complete layout still in progress or did i miss it?

Greetings